STP Super Seal R134A Air Con Stop Leak

Product Overview

Product Details

STP® Super Seal Air-Con Stop Leak Kit contains chemicals that are activated by moisture to form a patch as the refrigerant passes through a leak. It also contains a drying agent to eliminate moisture and dye to mark larger leaks.

Features and Benfits

• Repairs metal leaks – evaporator, condenser, compressor, accumulator, receiver/dryer.
• Seals rubber leaks – O-ring, gasket hoses.
• Does not contain R-134a – F-gas regulations compliant.

Instructions for use:

• Step 1: Using the R134a refrigerant with the colour coded charging gauge ( e.g. MAC134UK; AF1UK, for retail or AF6UK, with QC1HD for trade) connect the quick coupler to the Low-Side Charging Port, take a pressure reading then add enough refrigerant to enable the compressor to engage, “click in”
• Step 2: Swap to the Super Seal product, connect again to the same low-side port and add the whole can, shake well until empty then disconnect the Super Seal
• Step 3: Immediately reconnect the quick coupler of the STP R134a refrigerant with the colour coded charging gauge as mentioned above and carry on recharging/topping-up the system with refrigerant until the gauge needle stabilises in the BLUE zone

Additional Note:

• Please note: The super seal product works very quickly, so to prevent the super seal from sealing the charging port the system must be recharged/topped-up immediately!
• If you have a visible hole or a split in any component it will need to be replaced, the system pressure tested, vacuumed and recharged using professional equipment.
• Please note packaging may vary